• You are not logged in.
  • Index
  • Technical
  • Installation not working, what am I doing wrong?

    Installation not working, what am I doing wrong?

    • Started by Meg
    • 1 Replies:
    • Meg
    • New member
    • Reputation: 0
    • Registered: 06-Sep-2010
    • Posts: 2

    Downloaded setup.exe. Unzipped it. Ran setup.exe. It said the program was installed and I should restart. Restarted. But the layout is still QWERTY. What did I do wrong? On Windows XP SP3.

    Thanks.

    Offline
    • 0
    • Reputation: 214
    • From: Viken, Norway
    • Registered: 13-Dec-2006
    • Posts: 5,361

    Sorry for the late reply, didn't see this one before now.  :)

    Sounds like your install went well, but you still need to change the layout for it to be activated! If you have a little language button at your screen's lower right, press that; otherwise, navigate through Control Panels -> Regional and Language opt. -> Language (tab) -> Details... (button) -> phew, finally there! Now, Add Colemak if it isn't already there. You can set hotkeys for switching layout under Key Settings (I don't like them much and use a scripted solution instead). The final setup depends a bit on what your language was beforehand.

    *** Learn Colemak in 2–5 steps with Tarmak! ***
    *** Check out my Big Bag of Keyboard Tricks for Win/Linux/TMK... ***

    Offline
    • 0
      • Index
      • Technical
      • Installation not working, what am I doing wrong?